Help with Base + TS Conf double configuration
Posted: Wed, 03.01.2018 16:07:37
Hi everybody, and Happy New Year
During this holidays, I've finally found the time to update my ZX EVO to the dual config TS + Base, also in order to be able to use Zi-Fi.
I've followed the instructions on this forum (http://forum.tslabs.info/viewtopic.php?f=31&t=189), the update seems to have worked, but I have encountered a problem that do not allow me to use TS-Conf.
Starting from Base EVO with 60Hz VGA, when I press Alt+Ctrl+F12, the system seems to switch to TS-Conf, but no image is displayed because my monitor says that it does not recognize the VGA signal frequency.
I've tried pressing ScrLock and Shift+ScrLock while in this mode, but nothing appears on screen (the ScrLock LED on the keyboard goes on and off correctly).
Pressing again Alt+Ctrl+F12 the EVO returns regularly to Base EVO, and the VGA 60Hz screen is displayed back.
Pressing Menu+F3 from the EVO Base, the screen switches from 50Hz to 60Hz VGA and back as expected.
When in EVO Base screen the following versions are displayed:
ZxEvo&Base 10.06.2017 beta
ZxEvoAVRBoot 23.01.2012
Are those correct ?
Why TS-Conf is not displayed at 60Hz as Base ?
Should I use the SCART cable ?
Thanks a lot for any help !
Fabio.
(Milan - ITALY)
During this holidays, I've finally found the time to update my ZX EVO to the dual config TS + Base, also in order to be able to use Zi-Fi.
I've followed the instructions on this forum (http://forum.tslabs.info/viewtopic.php?f=31&t=189), the update seems to have worked, but I have encountered a problem that do not allow me to use TS-Conf.
Starting from Base EVO with 60Hz VGA, when I press Alt+Ctrl+F12, the system seems to switch to TS-Conf, but no image is displayed because my monitor says that it does not recognize the VGA signal frequency.
I've tried pressing ScrLock and Shift+ScrLock while in this mode, but nothing appears on screen (the ScrLock LED on the keyboard goes on and off correctly).
Pressing again Alt+Ctrl+F12 the EVO returns regularly to Base EVO, and the VGA 60Hz screen is displayed back.
Pressing Menu+F3 from the EVO Base, the screen switches from 50Hz to 60Hz VGA and back as expected.
When in EVO Base screen the following versions are displayed:
ZxEvo&Base 10.06.2017 beta
ZxEvoAVRBoot 23.01.2012
Are those correct ?
Why TS-Conf is not displayed at 60Hz as Base ?
Should I use the SCART cable ?
Thanks a lot for any help !
Fabio.
(Milan - ITALY)