Page 1 of 1

My ZX Evo purchase and update to TSConf

PostPosted: Fri, 06.04.2018 09:45:07
by chernandezba
Hi!

Finally received my ZX Evo yesterday :) I even updated to TSConf and tried some demos/games.
I had a "panic" moment (indeed, two hours) when I didn't succeded installing TSConf and (I Think) I had the TSConf rom updated but the old firmware...
Anyway, I could update it using the boot recovery process (pressing reset when powering on); I think a very advanced feature, the way you can recover it...

You can see some photos / videos on my Twitter account
https://twitter.com/zesarux

And on my FB account (ZEsarUX group)

Cheers

Re: My ZX Evo purchase and update to TSConf

PostPosted: Fri, 06.04.2018 10:22:44
by VBI
Cool! Welcome to the Club!
and, so about TS Config Net? :D

Re: My ZX Evo purchase and update to TSConf

PostPosted: Fri, 06.04.2018 10:56:05
by chernandezba
VBI wrote:Cool! Welcome to the Club!
and, so about TS Config Net? :D


I saw the ZiFi module, but I'm not sure if I have to solder something on the board and where I have to plug it....

Re: My ZX Evo purchase and update to TSConf

PostPosted: Fri, 06.04.2018 11:03:33
by chernandezba
Saw some info here:
http://hype.retroscene.org/blog/382.html

So it only has to be connected to the "X14. AVR JTAG for ATMEGA128" connector?
That connector is for "Connector for programming ATMEGA128 via JTAG ICT". Why the Wifi module has to be plugged there?

Re: My ZX Evo purchase and update to TSConf

PostPosted: Fri, 06.04.2018 11:56:20
by VBI
dont read this shit. :lol:

please check this post and topic
Zifi inserted in port Х5

Re: My ZX Evo purchase and update to TSConf

PostPosted: Fri, 06.04.2018 12:05:18
by chernandezba
VBI wrote:dont read this shit. :lol:

please check this post and topic
Zifi inserted in port Х5


Hehe thanks! It seems easy. But should I cut 1 pin of the wifi board, to receive 5V instead as 12V? As seen on the photo...